iM3 Catalogue - Europe - Flipbook - Page 96
ADVANCED BURS
A quick guide to iM3 burs for use in high-speed handpieces, low-speed
contra-angles, or straight nose cones
Friction Grip (FG) Standard-Length Burs
Normally used in high-speed handpieces. FG burs fit all standard high-speed
handpieces. Maximum speed 400,000 rpm.
g
m lon
1m
19–2
Friction Grip (FG) Feline-Length Burs
Feline-length burs are similar to standard friction grip burs but feature a
shorter shank. Ideal for use in smaller mouths.
g
m lon
16 m
Friction Grip (FG) Surgical-Length Burs
These burs are 25 mm long and used in suitable high speed handpieces.
The extra length provides greater access for when a little more reach is
needed in larger mouths and hard-to-reach areas. Never pull a bur
out of the high-speed handpiece to try to give it more
length.
g
m lon
25 m
CO N S U M A B L E S
Right Angle (RA) Burs
These burs have a 22 mm long shank and a small notch at the end of the shank for
locking the bur in place. These burs are commonly used in low-speed contra-angles
connected to electric micromotors or low-speed air-driven handpieces.
20,000–30,000 rpm. Please note that these burs do not fit into
iM3 high-speed handpieces.
g
m lon
22 m
HP Burs
These burs are suitable for rabbit dentistry and orthopaedics. HP burs are 45 mm long,
providing the extra length needed for large companion animals, domestic animals,
and exotic species. They are used in low-speed handpieces fitted with a 1:1
straight nose cone and can drill through thick bone for surgical,
orthopaedic, and endodontic procedures.
Page 92
www.im3vet.eu
www.im3vet.eu
g
m lon
45 m
